Table of Contents
Advertisement
7.
Put the lid onto the build unit, so that you can proceed with another activity, such as powder
recovery.
CAUTION:
8.
Check the area and clean up any spilled powder, then follow the regular cleaning procedure: see
Clean the working area on page
9.
Close the door of the powder management station. It then prepares itself for the next job.
Quick-clean device
Always follow the steps of the procedure in the order presented.
Safety warnings
For more safety information, see
1.
Ensure that an empty build unit is inside the powder management station.
2.
From the left menu of the front panel, select the settings icon
clean device.
NOTE:
the left menu of the front panel, select the tasks icon
Quick clean device.
3.
If the internal vacuum system is available, the process starts immediately. If not, follow these steps
to use an external vacuum system.
a.
On the front panel, a message is displayed advising you to connect the external vacuum
system. Connect the external vacuum cleaner to the vacuum system inlet, located next to
the manual aspiration hose. See the specifications and the position of the external vacuum
cleaner.
Do this smoothly, taking care not to generate any spillage.
Safety precautions on page 2
You can also access the quick-clean device process through the maintenance tasks. From
65.
, then tap Maintenance > Quick
. Navigate to Recommended tasks and tap
Quick-clean device
47
Advertisement
Table of Contents
Troubleshooting
