HP 10343B Operating Manual page 25

The HP 10343B can also be connected to one end of the bus by the
following steps:
1. Turn off the power to your bus system and logic analyzer.
2. Remove a terminator from one end of your bus system.
3. Connect the shielded cable supplied with the HP 10343B from the
shielded connector on the HP 10343B to the location on your bus
system in which the terminator was located.
4. Connect the terminator to the unused shielded connector on the
HP 10343B.
5. Turn on the bus and logic analyzer.
Note
The SCSI Bus system must be terminated at both ends for proper
preprocessor operation.
Figure 2-5. Connecting to the Bus
SCSI Bus Preprocessing
2-13