HP 10343B Operating Manual page 44

ISCSIWRM - Is a special case inverse assembler designed for Write Once
Read Multiple Devices. The following commands set it apart from
ISCSIDER.
• 15H Mode Select
• 1AH Mode Sense
• 28H Read
• 2EH Write and Verify
• 2FH Verify
ISCSIOPT - Is for Optical Memory Devices.
Note
For Read Only Direct Access Devices, "ISCSIDIR" should be
used with the Group 0 (6 byte) commands and"ISCSIWRM*
should be used with Group 1(10 byte) commands.
There is a good possibility that your SCSI Bus system will be made up of
several different device types. Often, even the initiator and the target may
be different device types. In this situation you may need to decide which
inverse assembler will best fit your needs. To make it easier to select the
appropriate inverse assembler, the commands for each device type are
listed in tables 3-1 through 3-10. By comparing the commands for each
inverse assembler, the most appropriate inverse assembler can be selected.
HP 10343B Inverse Assemblers
3-3