Toro Reelmaster 5510 Operator's Manual page 106

Backlapping the Cutting Units (continued)
Contacting the cutting units when they are moving will result in death or serious
injury.
To avoid personal injury, ensure that you are clear of the cutting units before
proceeding.
Never use a short-handled brush.
4. If the reels stall or become erratic while backlapping, select a higher reel-speed setting
until the speed stabilizes, then return the reel speed to your desired speed.
5. If you need to make an adjustment to the cutting units while backlapping, perform the
following steps:
A. Move the Lower Mow/Raise lever rearward and disengage the PTO.
B. Shut off the engine and remove the key.
C. Adjust to the cutting units.
D. Repeat steps
6. Repeat step
Finishing Backlapping
1. Move the Lower Mow/Raise lever rearward and disengage the PTO.
2. Shut off the engine and remove the key.
3. Move the backlap levers to the F (mow) position.
If you do not change backlap lever to the F (mow) position after backlapping, the
cutting units will not function properly.
Backlap lever (mow position—front cutting units)
Maintenance: Cutting Unit Maintenance
1 through 3.
3 for the other cutting units that you want to backlap.
Page 6–39
DANGER
IMPORTANT
IMPORTANT
G417040
Backlap lever (mow position—rear cutting units)
3464-490 A