During Operation; Overview Of The Machine Operating Characteristics; Machine Operation - Toro Reelmaster 5510 Operator's Manual

Overview of the InfoCenter Display (continued)
• The instantaneous speed is displayed in the upper left-hand corner of the cruise control
and virtual pedal stop screens.
• The traction speeds are estimated, and calibrated to be most accurate at 8.0 km/h (5.0
mph) while mowing. Displayed speeds are accurate when it is 0.8 km/h (0.5 mph) above
or below the display speed while driving on dry, flat pavement.
• Contact your authorized Toro distributor if the machine's observed speeds deviate more
than 2.4 km/h (1.5 mph) from the displayed speeds.

During Operation

Overview of the Machine Operating Characteristics

• When you remove your foot from the traction pedal, the machine dynamically brakes to a
stop.
• The pedal controls are optimized to provide a reactive yet stable response, allowing you
to maintain consistent control over rough terrain, while still allowing for quick, smooth
braking.
• The maximum speeds set in the PIN protected menu settings are set by the supervisor to
limit the machine's maximum traction speed.
• The achievable traction pedal use, cruise control, and pedal stop traction speeds are all
limited by the maximum speeds set in the PIN protected menu.

Machine Operation

• If an obstacle is in the way, lift the cutting units to mow around it.
• When transporting the machine between work areas, shut off the PTO, and raise the
cutting units to the fully upward position.
• Always drive slowly in rough areas.
• Never shut off the machine while driving the machine.
Practice Operating the Machine
To get familiar with the features of the machine, practice operating the machine.
1. Lift the cutting units, disengage the parking brake, press the forward traction pedal, and
carefully drive to an open area.
2. Practice driving the machine, because it has a hydrostatic transmission and its features
can differ from other turf-maintenance machines.
3. Practice moving forward and reverse, and starting and stopping the machine. To stop
the machine, remove your foot from the traction pedal and let it return to N
Note:
switch or use the reverse pedal to stop.
3464-490A
When going downhill in the machine, you may need to engage the parking-brake
Page 5–13
.
EUTRAL
Operation: During Operation