Installing the Rear Cutting Units to the Lift Arms
Cutting Units adjusted for a 1.2 cm (3/4 inch) or Higher Height of Cut
1. Install the rear cutting units to the lift arms as
shown.
2. Lock the cutting-unit pivot for cutting grass on
a hill side.
Installing the Rear Cutting Units to the Lift Arms
Cutting Units adjusted for a 1.2 cm (3/4 inch) or Lower Height of Cut
1. Remove the lynch pin
securing the to the pivot yoke
, and slide the shaft out of the lift arm.
2. Assemble the pivot yoke
frame shaft
3. Assemble the cap
align the holes in the carrier frame shaft, pivot
yoke, and cap.
4. Secure the pivot yoke and cap to the carrier
frame shaft with the snapper pin
5. Lock the cutting-unit pivot for cutting grass on
a hill side.
6. Slide a cutting unit under the lift arm.
7. Insert the pivot yoke into the lift arm
secure the lift-arm shaft
the lynch pin
8. Repeat this procedure for the other rear cutting
unit.
Setup: Installing the Cutting Units
and washer
to the lift arm
onto the carrier
.
to the pivot yoke, and
to the lift arm with
and washer
.
Page 3–9
G402695
G402723
.
G402724
, and
G402725
3464-490 A