Sony DTC-87ES Operating Instructions Manual page 17

'Or: -x-y-14(- mey-lellare|
1 Turn on the power.
2 Press OPEN/CLOSE.
3 Insert the cassette.
Insert the cassette
Window side up until it clicks.
4 Press OPEN/CLOSE.
The lamp in the cassette compartment lights.
To remove the cassette
Press OPEN/CLOSE.
On a digital audio tape
Only the digital audio tape made especially for DAT deck is
required.
Unlike an ordinary cassette tape, a digital audio tape can
be used only one side.
e Digital audio tape is designed to avoid a dust. Do not
open the inside of the tape.
@ The hole at the back of a tape is a detector slot. Do not
cover the slot.
To prevent accidental erasure
When a recording is made, any previously recorded signal
will be erased automatically. To prevent accidental erasure,
set the safety tab to the position shown in the illustration.
With the hole open, rewriting sub codes cannot be
performed.
Recording is impossible (with the hole
open).
Recording is possible (with the hole
covered).
Notes On the sampling frequency
e@ When you turn on the power, the Il indicator blinks for a When a cassette is inserted and a source program is play
moment in the display window. During this period, no back, the sampling frequency of the source program
buttons other than OPEN/CLOSE and » are operative. Wait appears in the display window.
until blinking stops and i goes off.
® When inserting the cassette, do not push the cassette
compartment closed. Be sure to use the OPEN/CLOSE
button,
ang