Sony DTC-87ES Operating Instructions Manual page 23

Fade-in/Fade-out Recording CD Synchronized Recording
lf a Sony Compact Disc player with a Remote Commander
FADER is available, you can start playback of the CD player and
the recording of the DAT deck, using the Remote
Commander.
Position the Remote Commander so that the signal reaches
the remote sensor of both the DAT deck and the CD player.
To start recording
Use the Remote Commander of the DAT deck.
1 Insert a cassette.
Fade-in Recording 2 Insert the disc in the CD player.
3 Press CD SYNCHRO STANDBY on the Remote
Commander of the DAT deck.
The deck enters the record-pause mode.
1 Press REC at the starting point of recording.
The deck enters the record-pause mode.
2 Press FADER at the point where you want to start
fading in.
The FADE IN indicator blinks, and the sound fades in.
4 Press CD SYNCHRO START on the Remote
Commander of the DAT deck.
Recording on the DAT deck starts, and about 1 second
later, playback of the CD player starts.
To get the original sound level during a fade-in
To momentarily stop recording of the DAT deck and
playback of the CD player, press the i buttons on both the
DAT deck and the CD player.
Fade-out Recording
Press FADER at the point where you want to start
fading out.
The FADE OUT indicator blinks, and the sound being
recorded fades out.
A countdown starts, and the deck enters the record-pause
mode after the 0.0s indicator appears.
To control the CD player with the Remote Commander
of the DAT deck
The following operations are possible:
Playback... Press if twice.
Pause... Press Monce.
AMS... Press Ké<d OF PI. [seSke)
When a desired selection is OO Qiaia
located using the above aogeo
oon oo
aogea
oa! a
To designate a desired duration of fade-in/fade-out
You can designate a desired duration of fade-in/tade-
out, from0.2 seconds to 15 seconds. Fade-in/fade-out
is performed in 5 seconds unless you designate a
different duration.
If you turn off the unit after designating the desired
operation, you can start CD
synchronized recording.
duration of fade-in/fade-out, the duration remains Qaneo
memorized. e2ooSs
ao (22)
1 Choose either FADE IN or FADE OUT by CD operating buttons
pressing FADER in the stop mode. ooag
2 Designate a desired duration by pressing
<4 OF Pe.
Each time pressing << or », a duration in the
display changes as follows:
from 0.2 sec. to 3.0 sec.: in 0.2 sec. intervals
from 3.0 sec. to 5.0 sec.: in 0.4 sec. intervals
from 5.0 sec. to 15 sec.: in 1 sec. intervals.
23