Interfaces; Pn Basic Connection Module; Description - Siemens SINUMERIK 840D sl Equipment Manual

Connecting
7.3 PN Basic connection module
7.2.4

Interfaces

Information about the interface assignment on the PN terminal box can be found in the
"Handheld Terminal HT 2" manual under "Connecting" → "Terminal Box PN" → "Interface
assignment on the PN Plus terminal box"connection.
7.3

PN Basic connection module

7.3.1

Description

The connection module Basic PN was specially developed for installation in the control cabinet.
The terminating connector protrudes through the panel of the control cabinet so that the HT 8
can be connected from the outside.
Figure 7-5
The connection module Basic PN is not hot plug-capable.
The HT 8 can either be connected directly to the NCU or to the IPC as thin client.
104
System configuration (example)
Handheld Terminal HT 8
Equipment Manual, 02/2024, A5E52918633B AA