Advertisement
(1)
IR unit attachment and soldering
Fold the two pawis down inside
and soider them.
(Fold the paws)
* When folding the pawis, use the base plate in order not to apply a
stress to the PWB.
(Front)
"Solder over the pattern.
(2) Ni-Cd detection switch positioning and soldering
(Note) Attach the parts closely
__.......onee the PWB
(Ok)
:
|
|
<
"The pins should be firmly
cae
! inserted into the hole in
5
the PWB.
s(NG)
If there is a float (improper attachment), Ni-Cd detection cannot be
pertormed in the set condition.
* Use
solder of 0.8 (diameter).
(No need
to cut.) (KRISRMA,
diameter of 0.5)
any
clearance.
Do not
alow
X Soldering temperature should be Max. 320°C (within 5 sec).
(Excessive heat may cause malfunctions.)
Advertisement
