Advertisement
3. Speaker lead wire removal
PWB FPC removal
Remove the solder of the speaker lead wire
.
and remove the read wre from the fixing rib.
es
(A
<Note>
When unlock the 40-pin connector, be careful not to damage
it
Unlock
the 40-pin con-
nector of the PWB.
Remove the FPC.
Remove the speaker lead wire solder.
6. 68-pin eject removal
<Note>
When
soldering the lead wire of the speaker,
solder at
temperature of Max. 608 F for Max. 5 sec and do not mis-
take the lead wire color.
4, Pressure angle removal
9
1
|
GB)
|
Remove two fixing screws © of the eject unit.
|
Remove paw! @ from the PWB and pull out the unit.
| oe
<Note> when attaching the eject unit, lift section © slightly and in-
'sert and attach it.
7. Chassis A removal
Pressure angle (Place so that the
projected portion faces upward.)
Remove one screw ®, one screw ®), two screws ©, two screw ©),
two screws ©), and two screw ©.
5. PWB unit removal
Reverse
the PWB.
Do not remove screw @.
<Note> When attaching chassis A, tighten the screws in the se-
quence of @ to ©.
Advertisement
