Step 1B: Configure Network Interfaces - NEC SV8100 Configuration Note

4.1.2

Step 1b: Configure Network Interfaces

This step describes how to configure the IP network interfaces for each of the following
interfaces:

LAN VoIP (assigned the name "Voice")

WAN VoIP (assigned the name "WANSP")

To configure the IP network interfaces:
1. Open the IP Interfaces Table page (Configuration tab > VoIP menu > Network > IP
Interfaces Table).
2. Modify the existing LAN network interface:
a. Select the 'Index' radio button of the OAMP + Media + Control table row, and
then click Edit.
b. Configure the interface as follows:
IP Address
Prefix Length
Default Gateway
VLAN ID
Interface Name
Primary DNS Server IP Address
Underlying Device
3. Add a network interface for the WAN side:
a. Enter 1, and then click Add Index.
b. Configure the interface as follows:
Application Type
IP Address
Prefix Length
Default Gateway
VLAN ID
Interface Name
Primary DNS Server IP Address
Secondary DNS Server IP Address
Underlying Device
4. Click Apply, and then Done.
AudioCodes Mediant E-SBC
Parameter
Parameter
24
NEC SV8100 IP-PBX & BroadCloud SIP Trunk
Value
192.168.100.15 (IP address of E-SBC)
24 (subnet mask in bits for 255.255.255.0)
192.168.100.254
1
Voice (arbitrary descriptive name)
192.168.100.254
vlan 1
Value
Media + Control
82.153.203.53 (WAN IP address)
25 (for 255.255.255.128)
82.153.203.49 (router's IP address)
2
WANSP
82.153.203.49
8.8.8.8
vlan 2
Document #: LTRT-12530