Table of Contents
Advertisement
2-8
WARNING
I
To avoid injury to personnel and damage to the
equipment, at least two men are required to handle
the storage module unit drawer.
1.
Layout some type of protective material and carefully
turn and rest drawer on its right-hand side on top of
protective material.
2.
Remove the four rubber mounting pads and steel shipping
bar from bottom of drawer.
This hardware may be dis-
carded after installati6n.
3.
Locate right-hand slide assembly, as shown in Figure 2-5,
packaged with supplied hardware.
4.
Remove quick disconnect from outer slide by loosening the
two screws on quick disconnect catch (see Figure 2-5),
and lay aside outer right-hand slide.
5.
Place right-hand quick disconnect on right-hand side of
drawer and align mounting holes.
6.
Using the four countersunk flat-head screws and counter-
sunk washers supplied with slide kit, fasten right-hand
quick disconnect to right-hand side of drawer.
7.
Layout additional protective material and carefully turn
and rest drawer on its left-hand side on top of protec-
tive material.
8.
Locate left-hand slide assembly (reverse of what is shown
in Figure
2~5),
packaged with supplied hardware.
9.
Remove quick disconnect from outer slide by loosening the
two screws on quick disconnect catch and lay aside outer
left-hand slide.
10.
Place left-hand quick disconnect on left-hand side of
drawer and align mounting holes.
11.
Using the four countersunk flat-head screws and counter-
sunk washers supplied with slide kit, fasten left-hand
quick disconnect to left-hand side of drawer.
12.
Carefully rest expansion drawer on its base.
HONEYWELL CONFIDENTIAL
&
PROPRiETARY
(~
-',
\'c. __ /
Advertisement
Table of Contents
