Table of Contents
Advertisement
('
(
5.
6.
7.
The nut plate's four holes are drilled off center
and must be installed with narrow side in towards
slides at each corner of the cabinet frame.
If
installed backwards, the drawer will not slide in
and out of cabinet properly.
From front of cabinet, loosely install one nut plate on
each side of cabinet frame, ensuring that narrow side of
nut plate is facing in toward drawer to be installed.
Use hardware indicated in Figure 2-9 and Table 2-2.
From rear of cabinet, loosely install one nut plate on
each side of cabinet frame, ensuring that narrow side of
each nut plate is facing in toward drawer to be in-
stalled.
Use hardware indicated in Figure 2-9 and Table
2-2.
Tighten screws holding nut plates with an allen wrench
through access hole in frame; however, ensure that nut
plates are loose enough so that slotted ends of slide
assembly can be inserted between nut plates and frame.
8.
Locate both slide assemblies and adjust position of rear
recess bracket (see Figure 2-5,
item~)
so that slide
assemblies can be positioned in cabinet frame.
9.
Position slide assemblies in cabinet frame with both
slide's full extension release (on inner slide) down and
to the outside (adjusting screws and nuts should be
facing out to side of cabinet) as shown in Figure 2-5.
NOTE
Ensure slides are fully engaged with nut plate
before tightening.
10.
Tighten mounting hardware securing slide assemblies to
frame and tighten adjusting screws and adjusting nuts
that secure rear recess bracket to main bracket (see
Figure 2-5).
11.
Ensure that slide assemblies are aligned both horizontal-
ly and vertically and that they are parallel.
HONEYWELL CONFIDENTIAL
&
PROPRIETARY
2-17
Advertisement
Table of Contents
