Table of Contents
Advertisement
HP-IB INTERFACE/26067B
Section
II.
Installation and Configuration
2-1.
INTRODUCTION
This section
of the manual
describes
how to
install the HP-IB Interface (5062-0477)
into the
printer, how to adjust HP-IB cable loading, and
how to configure the HP-IB interface
functions
for the system.
It also covers unpacking
and
inspection
of the HP 26067B System Interface
kit.
2-2.
UNPACKING AND
INSPECTION
If the
shipping
container
is damaged
upon
receipt, request that the carrier's agent be present
when the kit is unpacked.
Inspect the kit for
damage (cracks, broken parts, etc.). If the kit is
damaged and fails to meet specifications,
notify
the carrier
and the nearest
Hewlett - Packard
Sales and Service Office (these offices are listed
at the back of this manual.)
Retain
the
shipping
container
and
packing
material
for
the
carrier's
inspection.
The
Hewlett- Packard
Sales and Service Office will
arrange
for the repair
or replacement
of the
damaged kit.
2-3.
INTERFACE
INST
ALL A
TION
Installation
of the interface
into
the printer
consists
of
removing/opening
the
printer
cover/panel,
adjusting
the
HP-IB
loading,
inserting the interface into the printer backplane
interface
connector,
and
configuring
the
interface.
Installation
of
the
interface
is
described in the following steps.
WARNING
Any operation which requires the
removal
of
the
printer's
protective
covers
must
be
performed
by
a
qualified
Hewlett-Packard
service
representative.
Unqualified
personel
may
contact
voltage
points
in
the
printer
causing
serious personal injury or death.
a. Set the Main Power On/Off
switch at the
back of the printer to off (0).
b. Remove the printer cover/panel
as directed in
the appropriate
printer service manual.
c. Adjust the HP-IB loads on the interface
as
required for the total system cable length (see
paragraph
2-6, Cable-I/O
Cable Loading).
d. Insert the HP- IB Interface
PCA into the rear
(I/O) printer slot.
e. Connect
the printer
ground
wire from the
printer Backplane/Analog
PCA to the HP-IB
interface PCA (see figure 2-1).
f. If the printer
is being installed and requires
configuration
and the configuration
requires
CE mode (see paragraph
2-5), for convenience
install the CE jumper mode in this step.
NOTE
The non -CE functions
can be
configured
when the printer
is
in the CE mode.
2-1
Advertisement
Table of Contents
