Table of Contents
Advertisement
Model 5344S
Installation
SECTION II
INSTALLATION
2-1.
INTRODUCTION
2-2.
This section contains information for unpacking, inspection, storage, installation, and
connection to the Hewlett-Packard Interface Bus.
2-3.
UNPACKING AND INSPECTION
2-4.
if the shipping carton is damaged, inspect the instrument for visible damage (scratches,
dents, etc.). If the instrument is damaged, notify the carrier and the nearest Hewlett-Packard
Sales and Support Office immediately (the offices are listed at the back of this manual). Keep the
shipping carton and packaging material for the carrier's inspection. The Hewlett-Packard Sales
and Support Office will arrange for repair or replacement of your instrument without waiting for
the claim against the carrier to be settled.
2-5.
PREPARATIONS FOR USE
2-6.
Power Requirements
2-7.
The HP 5344A requires a power source of 100-, 120-, 220-, or 240-volt ac, +5%,-10 %, 48 to
66 Hz single phase. The power consumption is approximately 125 VA. See Section I, Specifications
for description.
2-8.
Line Voltage Selection
CAUTION
Before connecting the instrument to ac power lines, be sure that
the voltage selector is properly positioned as described in the
following paragraph.
2-9.
The 5344A is equipped with a power connector module that has a plug-in printed-circuit
card line voltage selector to choose 100-, 120-, 220-, or 240-volt ac operation (see Figure 2-1).
Before applying power, the selector card must be set to the correct position and the correct fuse
must be installed as described in paragraph 2-13.
PC BOARD PART NUMBER IS
5020-8122
SELECTION OF OPERATING VOLTAGE
1. Open cover door and rotate fuse-pull to left.
2. Select operating voltage by orienting PC board
to position desired voltage on top-left side.
Push board firmly into module slot.
3. Rotate fuse-pull back into normal position
and re-insert fuse in holders, using caution to
select correct fuse value.
Figure 2-1. 5344A Line Voltage Selection
2-1
Advertisement
Table of Contents
