Table of Contents
Advertisement
Model 5344S
Operation and Programming
6.
Press the F2 key on the 5344A. The LED inside the key will light to indicate that it is waiting for a STOP
frequency to be entered and the entered value will be shown on the display.
7.
Using the 5344A Numeric Entry keys, press:
the 5344A should display:
2.040000000 GHz
To see the START Frequency value, press key FI. Unless Numeric Entry keys are pressed, the value will
remain unchanged. If an invalid value is entered, the previous value will remained unchanged, if a
value outside of the limits is entered, the value will default to the closest limit.
SWP TIME
8. Press the 5344A
0
The LED inside the key will light to indicate that the 5344A is waiting for Sweep Time value to be
entered.
9. Using the 5344A Numeric Entry keys press:
the 5344A will display:
100 ms
10.
Press the 5344A MANUAL LOCK key.
The LOCKED annunciator should light.
11.
If the FREQ LO annunciator lights, manually raise the frequency of the 8350A until the 5342A displays
2.02 GHz ±15 MHz. The 5344S will automatically tune the 8350A to the desired frequency.
12.
If the FREQ HI annunciator lights, manually lower the frequency of the 8350A until the5342A displays
2 GHz (±15 MHz). The 5344S will automatically tune the 8350A to the desired frequency.
13.
Notice that when either the FREQ HI or FREQ LO annunciators are on indicating that tuning is
required, the resolution on the counter decreases to 1 KHz. This allows a very fast update of the
counter display making tuning quicker and easier. The sweep is also halted until Lock is achieved.
NOTE
The 5344S will display error code Err 01 if the frequency of
the sweeper is changing too fast for the 5344S to follow. This
may occur for the following reasons:
a.
The 8350A is in SWEEP mode (vs. CW) and is sweeping, or
b.
When manually tuning the 8350A to within 15 MHz it is being
tuned too quickly.
Figure 3-10. Start/Stop in Manual (Continued)
3-36
Advertisement
Table of Contents
