Table of Contents
Advertisement
Model 5344S
Operation and Programming
The 5344S locks the signal source to the specified CW frequency. The signal source must be
manually adjusted to within 25 MHz of the desired CW frequency.
Connections:
FM
INPUT
FM
OUTPUT
10 MHz
jawiwHwwiaw
ooo
I QO
Q
Q
DDDQO
^
DQQ'
nnnnn nm OOOQO
OD
□□□□□ QUO □odoq
OOO
ODOOOOO □□□□□
p d
OOL
I a oooo ooo oooo©1
<§> «
» @
aoa ooo
aaa ooo
aoa aoo
□ a aaa
oaoaoa a
oooooo _
oooooo
n oooo ®
8350A
SWEEP
GENERATOR
OUTPUT
5344S
11691D
DIRECTIONAL
COUPLER
LOCKED SIGNAL
Example:
CW locked frequency at 2.000000000 GHz.
1.
Set MANUAL LOCK and AUTO LOCK off (lamp off). If AUTO LOCK is turned on, the 5344A will
display error code Err 10.
2.
Select CW mode on the 8350A. If the plug-in has a CW filter, turn it OFF. Verify the counter
SAMPLE RATE is not in HOLD.
3.
Using the 8350A DATA ENTRY keys, press:
The 8350A should display 2.000 GHz and the 5342A should display approximately 2 GHz.
4.
Using the 5344A Function keys, press:
a.
MODE until the CW annunciator lights. The MODE key will scroll through the four modes
of operation. If you pass CW, continue pressing MODE until you return to CW.
5.
Using the 5344A Numeric Entry keys, press:
The 5344A should display:
2.000000000 GHz
The 5344S always assumes that the remaining unentered digits are zero. Thus 1 Hz resolution
always occurs.
Figure 3-8.
CW
in Manual
3-31
Advertisement
Table of Contents
