Dell PowerConnect 3024 User Manual page 12

In the IP Settings page, you can manage the IP related information about the system. The page includes the following editable fields:
IP address
l
Gateway address
l
Network mask
l
IP Assignment Mode — Sets whether IP functionality is enabled through manual (static) configuration or set by Dynamic Host Configuration Protocol
l
(DHCP) or Boot Protocol (BootP).
Manual — Sets static IP address.
¡
BootP — Gets IP address from a BootP server.
¡
DHCP — Gets IP address from a DHCP server.
¡
To save any changes you make in this page for the current session, click Apply. To reset these fields to their current value, click Reload.
For IP address changes to take effect, perform the following steps:
1. From the Save Configuration page, save your changes beyond the current session.
2. Reboot the system from the System Manager/Reset page.
Security Administration
User Authentication Mode — Selects the authentication or authentication sequence required.
l
Local Only — The switch authenticates the user.
¡
Local then Remote — The switch attempts to authenticate the user first, and then a RADIUS server attempts to authenticate the user.
¡
Remote then Local — A RADIUS server attempts to authenticate the user first, and then the switch attempts to authenticate the user.
¡
Remote Only — A RADIUS server authenticates the user.
¡
RADIUS Server IP Address — Identifies the IP address of the RADIUS server.
l
RADIUS Shared Secret — Specifies the text string that is shared between the switch and the RADIUS server.
l
IP Filtering — Allows up to 16 IP addresses to access the switch management function, if enabled.
l
Password Admin — Enables or disables password protection.
l
NOTE: The default password is switch.
Allowed IP Addresses — Provides an option to enter up to 16 IP addresses in the Allowed IP Address table.
l
Disable Telnet/Web Access (Console Only) — Provides an option to enable or disable Telnet or Web access to the switch.
l
To save any changes you make in this page, click Apply. To reset these fields to their current value, click Reload.