Dell PowerConnect 3024 User Manual page 15

Link — Indicates the status of the link: Up or Down.
l
Admin Enabled — Allows the network administrator to manually disable a port.
l
State — Describes the state of the port as determined by the Spanning Tree Protocol.
l
Operating Parameters — Allows automatic or manual selection of port speed and duplex mode.
l
Flow Control Enabled — Allows automatic or manual selection of support for flow control.
l
GBIC
From the GBIC page, you can enable the GBIC slot instead of the built-in 10/100/1000BASE-T port for each of the two Gigabit Ethernet uplinks.
NOTICE: Enabling the GBIC port disables the built-in 10/100/1000BASE-T port.
To save any changes you make in this page for the current session, click Apply. To reset these fields to their current value, click Reload.
Address Manager
The Address Manager page includes links to the following pages:
Static Addresses
l
Dynamic Addresses
l
Address Aging
l
Static Addresses
From the Static Addresses page, you can specify the Media Access Control (MAC) address and port number of systems that are to remain available to the
switch for an indeterminate amount of time.