System Menu (System); Nap Timer (Nap Function) - Silvercrest 353496 2007 Operating Instructions And Safety Instructions

Turn the VOLUME |
♦
lowest volume level.
♦ Plug the jack plug of the headphones into the headphone socket
on the rear of the device. Sound playback now takes place only via the
connected headphones.
Set the desired volume using the VOLUME |
♦

System menu (System)

NOTE
► The system menu can be called up during operation and also in standby
mode.
► If no setting is made in the system menu within 20 seconds, the device exits
the settings menu.
Press the INFO/MENU button
♦
Press the TUNE+
♦
turn the VOLUME |
the display
Press the VOLUME |
♦

Nap timer (NAP function)

Using the NAP function, you can set a timer alarm that will wake you up with an
alarm signal after 1–120 minutes.
Setting the nap timer
♦ Call up the system menu. The first menu item to appear is the NAP timer.
Press the VOLUME |
♦
Press the TUNE+
♦
between 001 and 120 minutes.
Press the VOLUME |
♦
and start the nap timer. After exiting the system menu, N appears on the
display
SRH 5 C3
ENTER / SCAN dial
8
or TUNE−
ENTER / SCAN dial
1
.
ENTER / SCAN dial
ENTER / SCAN dial
8
or the TUNE− button
6
ENTER / SCAN dial
ENTER / SCAN dial
1
followed by the remaining minutes or seconds.
6
anticlockwise to the
ENTER / SCAN dial
4
for approx. 2 seconds.
7
button (several times if necessary) or
6
until System appears on
6
to confirm the selection.
6
to confirm the selection.
7
or turn the VOLUME |
to set the alarm time in 1-minute steps
6
to confirm the selection
e
6
.
GB │ IE 25 ■
│