Ip Address Setting Using The Arp/Ping Command - Canon LBP-3300 Network Manual

2
6
7
Next, install the Canon CAPT Print Monitor. (See p. 2-26)

IP Address Setting Using the ARP/PING Command

1
2
2-22 Installing the CAPT Software
G When your case falls within neither of the above cases
❑
If the display of NetSpot Device Installer falls within neither of the above even if
you are using an operating system other than Windows XP Service Pack 2 or
another operating system equipped with Windows Firewall, the network cable
is connected properly, and the printer is ON, there is a possibility that a device
that has the same IP address as the default IP address of the printer exists on
the network. In this case, turn off the device that has the same IP address or
remove the device from the network, and then perform the procedure from
Step 1 (See p. 2-16) again. After completing the settings for this printer, restore
the devices to their original states. If this method is impossible, set the IP
address using the ARP/PING command. For details on the procedure for
setting the IP address using the ARP/PING command, see "IP Address Setting
Using the ARP/PING Command," on p. 2-22.
After completing the settings, click [OK].
When the message <The device has been reset.> appears,
click [OK].
After completing the reset, the settings are enabled.
Run Command Prompt or MS-DOS Prompt.
For Windows XP/Server 2003: From the [Start] menu, select [All Programs] ©
[Accessories] © [Command Prompt].
For Windows 2000: From the [Start] menu, select [Programs] © [Accessories] ©
[Command Prompt].
For Windows Me: From the [Start] menu, select [Programs] © [Accessories] ©
[MS-DOS Prompt].
For Windows 98: From the [Start] menu, select [Programs] © [MS-DOS Prompt].
Enter the following command, then press the [ENTER] key on
your keyboard.
arp -s <IP Address> <MAC Address>