Fujitsu ScanSnap S300 Operator's Manual page 165

6. Load the document onto the paper chute.
•
Place all documents in the center under the pick roller.
ATTENTION
(Documents that are not under the pick roller cannot be fed.)
•
Adjust the side guides to the widest document.
•
For smaller documents which cannot contact the side guide, load a few sheets
of documents at a time. Carefully load them straight into the ADF. If the
documents are skewed during a scan, the quality of scanned images may be
degraded (chipped images/slant lines produced) or scanned images may be
output in different size from the original.
If you have difficulties in feeding documents straight, it is recommended to
scan documents in several batches and enable continuous scanning; scan
documents of about the same width in one batch.
Note that smaller documents that cannot be guided by the side guide may
cause a jam.
6.1 Using ScanSnap Manager
Width of the pick roller
ScanSnap S300 Operator's Guide
6
145