Pioneer PDP-433CMX Technical Manual page 117

[433CMX/433MXE]
2) Connection to a stereo amplifier
1. Switch off the power of the amplifier.
2. Connect the input terminals of the speaker system
and the speaker output terminals of the stereo
amplifier with the accessory speaker cable. The
polarity of the input terminals is plus ª for the red
terminal (the terminal on the right side in the
following figure) and minus · for the black terminal
(the terminal on the left side in the following figure).
1. Remove the insulation
and twist the core ends
together.
· terminal
(Speaker output terminals of the ste-
reo amplifier)
• After connection to the terminals, pull lightly on the cable to
confirm that the tips of the cable are connected positively to
the terminals. An imperfect connection can cause sound
interruptions and noise.
• When cable cores stick out and ª and · lines are short-
circuited, an excessive load will be applied to the stereo
amplifier and the operation will stop or trouble will be caused.
• When the polarity is reversed for one speaker (left or right) at
the time of connection to the stereo amplifier, the bass
reproduction will be reduced, the sound positioning will be
lost, and a correct stereo effect will not be obtained.
2. Push the lever, insert the
cable into the hole, and
release the lever.
ª terminal
To the · termi-
To the ª termi-
nal nal
Speaker System: PDP-S07-LR
3) Installation to commercial mounting fittings
This unit includes M8 (ø25) washers for installation on
commercial mounting fittings.
Washer
M8 (ø 25)
4) Cabinet maintenance
• Use a polishing cloth or dry cloth to wipe off dust and
dirt.
• When the cabinet is very dirty, wipe with a soft cloth
moistened with water-diluted cleanser; then wipe again
with a dry cloth. Do not use furniture wax or cleaners.
They may damage the surface of the cabinet.
• Never use thinner, benzine, insecticide sprays and other
chemicals on or near the cabinets, since these will
corrode the surfaces.
• When a chemical cloth is used, read the cautions for
the chemical cloth carefully.
• Installation is made by two-point
fixing at the top side mounting
holes for commercial mounting
fittings. As these two mounting
holes are not at the same level,
washers are used to compensate
for this difference.
117