Pioneer PDP-433CMX Technical Manual page 185

4) <GSO> (GET STATUS OPTION) Set data for OPTION will be output as follows.
Order
1 POWER CONTROL
2 OSD display
3 FULL MASK
4 R SIDE MASK LEVEL
5 G SIDE MASK LEVEL
6 B SIDE MASK LEVEL
7 MASK CONTROL
8 ORBITER MODE
9 INVERSE MODE
10 COLOR MODE
11 MIRROR MODE
12 FAN CONTROL
13 MONITOR NAME
14 SLOT INPUT
15 TEMPERATURE
16 HOUR METER
17 KEY LOCK
(NOTE) Dummy data will be output when the PDA-5002 is connected.
TEMPERATURE (3 bytes)/2 + 5 = Outside air temperature (°C) sensor value
(NOTE) Control the above sensor value so it does not exceed the values shown below.
PDP-503CMX/PDP-503MXE: 45
PDP-433CMX/PDP-433MXE: 53
When installing it, measure the surrounding temperature to make sure that all conditions stipulated in
surrounding temperature conditions in "3. Installation Environment" are satisfied. Be particularly sure to
confirm this when installing it as stipulated in 3.5, 3.6 Special Installation.
Data
RS-232C Adjustment Mode
Size Output
3byte Same as RS-232C command
1byte 0: OSD display disabled
1: OSD display enabled
3byte Same as RS-232C command
3byte Adjustment value
3byte Adjustment value
3byte Adjustment value
1byte 0: Fixed, 1: Shifts
1byte 0: OFF, 1: ON
1byte 0: OFF, 1: ON
1byte 1: COLOR MODE1
2: COLOR MODE2
1byte X: Left-right reversal
Y: Top-bottom reversal
Z: Top-bottom and
left-right reversal
N: OFF
1byte A: AUTO
M: MAX
12byte
1byte 0: VIDEO (RGB)
1: COMPONENT1
2: COMPONENT2
3byte
5byte
1byte 0: Lock released
1: Lock applied
Remarks
(NOTE)
185