Configuring Snmp Alerts - Dell POWERVAULT MD3600F Owner's Manual

9 For the selected e-mail address, in Frequency, select:
• Every event—Sends an alert e-mail whenever an event occurs. This is
the default option.
• Every x hours—Sends an alert e-mail after the specified time interval
if an event occurred during that time interval. You can select this
option only if you have selected either Event + Profile or Event +
Support in the Information To Send drop down list.
10 Click OK.
An alert icon is displayed next to each node in the Tree view where an alert is
set.
To ensure that the e-mail is sent successfully:
• You must provide a SMTP mail server name and an e-mail sender address
for the e-mail addresses to work.
• The e-mail addresses that you had previously configured are displayed in
the Configured e-mail addresses area.
• You must use fully qualified e-mail addresses, for example,
name@mycompany.com.
• You can configure multiple e-mail addresses before you click OK.

Configuring SNMP Alerts

To add a management console to the list of addresses configured to receive
SNMP alerts:
1 Open the Configure Alerts dialog by performing one of these actions:
• In the Tree view or the Table view on the Devices tab in the EMW,
select a node, and select Edit Configure Alerts. Go to step 3.
• In the Setup tab in the EMW, select Configure Alerts. Go to step 2.
2 Select one of the following radio buttons to specify an alert level:
• All storage arrays—Select this option to send an alert notification
about events on all storage arrays.
• An individual storage array—Select this option to send an alert
notification about events that occur in only a specified storage array.
Configuration: About Your Storage Array
83