Dell POWERVAULT MD3600F Owner's Manual page 84

These results occur, depending on your selection:
If you select all storage arrays, the Configure Alerts dialog is displayed.
•
• If you select an individual storage array, the Select Storage Array
dialog is displayed. Select the storage array for which you want to
receive alert notifications and click OK. The Configure Alerts dialog is
displayed.
NOTE:
the LEDs of the storage array.
3 Select the SNMP tab to configure the SNMP alert destinations.
• Adding an SNMP address—In Community name, type the
community name. In Trap destination, type the trap destination, and
click Add.
NOTE:
Interchange (ASCII) string that identifies a known set of network management
stations and is set by the network administrator. The default community name
is the string "public".The trap destination is the IP address or the host name of
a computer running an SNMP management application. An example of a
SNMP enabled management application is the Dell Management Console. For
more information on Dell Management Console, see dell.com.
• Replacing an SNMP address—Select the SNMP address in the
Configured SNMP addresses area, type the replacement community
name in Community name and the trap destination in Trap
destination, and click Replace.
• Deleting an SNMP address—Select the SNMP address in the
Configured SNMP addresses area, and click Delete.
• Validating an SNMP address—Select the SNMP address in the
Configured SNMP addresses area, and click Test. A test message is
sent to the SNMP address. A message box with the results of the
validation and any error information is displayed.
4 Click OK.
An alert icon is displayed next to each node in the Tree view for which an
alert is set.
84
Configuration: About Your Storage Array
If you do not know which storage array to select, click Blink to turn on
The community name is an American Standard Code for Information