Upgrading Rom/Ram - NEC MOBILEPRO 700 Quick Manual

Do not connect the internal modem to a digital private branch exchange connector, or the digital side of an integrated
digital network. Use only analog phone connections. Failure to do so may result in explosion or fire.
During thunderstorms be sure to disconnect the modem phone cable from the MobilePro H/PC. Failure to do so may result
in explosion or fire.

UPGRADING ROM/RAM

You can upgrade MobilePro ROM/RAM by replacing the currently installed ROM module with an upgraded ROM/RAM
module.
Changing the RAM or ROM module erases all user data and program memory. Make sure you perform a full backup
to your desktop or notebook before continuing.
Upgrade ROM/RAM as follows:
Save your data to a notebook or desktop computer, power off the MobilePro, and close the display panel.
Disconnect any peripheral devices attached to the MobilePro, such as the AC adapter.
Remove the Main and Back-up batteries. See "Battery Replacement" for details.
Turn the MobilePro over and locate the screw that secures the ROM/RAM bay cover.
Using a small screwdriver, remove the screw and the bay cover. (The MobilePro does not power on while the ROM/RAM
bay cover is removed.)
Using a small screwdriver, remove the screw on the ROM or RAM module.
Gently lift up the ROM or RAM module to disconnect it from its connector and remove it from the bay.
Insert the upgraded ROM or RAM module into the bay, aligning the connector on the module with the one in the bay.
Gently press on the module just above the connectors until the connection is secure.
Replace the bay cover and cover screw.
Install the Main and Back-up batteries. See "Installing Batteries" for details.
The MobilePro will not power on unless the ROM/RAM bay cover is secured.
warning
WARNING