Connecting Vscom 200 H (Interface Expansion); Connecting External Hard Disks; Connecting A Malfunction Relay - Bosch DB18C3100R2 Installation Manual

DiBos/DiBos Micro
9.3

Connecting VSCom 200 H (Interface Expansion)

To be carried out by authorized personnel only!
NOTICE!
Only the card type VSCom 200 H PCI may be used.
When retrofitting the interface expansion card, the following installation must be carried out.
1.
2.
3.
4.
9.4

Connecting External Hard Disks

An SCSI controller must be installed in order to connect the external hard disk housing. The
type and number of hard disks that can be connected can be found in the price list.
External hard disks must be switched on before booting the PC.
NOTICE!
Only the following card type may be used as an SCSI controller: LSI Logic 320 MB Ultra Wide
68 PIN HD SYM 21320.
CAUTION!
Do not position the SCSI cable near to a power cable. This influences the transmission rate
and may cause the connection to be interrupted.
9.5

Connecting a Malfunction Relay

The malfunction relay is connected to a relay output. It must be activated in the configuration
(see Section 6.5.2 Configuring Relay Outputs).
The following events are signaled by the malfunction relay.
–
–
–
–
–
–
–
–
–
–
–
Bosch Sicherheitssysteme GmbH
Switch off the computer and insert the interface expansion card in the appropriate
computer slot.
Reboot the computer.
Log on as Administrator.
The system automatically recognizes the interface expansion card.
The camera does not deliver a video signal
The logbook cannot be created or written
The images could not be recorded by the database server
Database server could not be started
Hard disk failure: Drive X deactivated, drive X not deactivated
The hard disk is full (protected image data)
Internal database error
Device could not be started
Grabber card not working
Export video scheduler error
Reference image check failed
Installation Guide
Connections | en 129
F.01U.033.308 | V7 | 2009.09