Bosch DB18C3100R2 Installation Manual page 68

68 en | Default Configuration
5
6
7
8
9
10
F.01U.033.308 | V7 | 2009.09
Pre-alarm time [sec.]:
Alarm recording
Rate:
Post-alarm time
[secs.]:
Continuous recording
Rate:
Delete old video
Older than [days]:
Delete protected data: Check box is activated: Protected data is automatically
Default settings
Copy settings to other
time periods...
Save
Installation Guide
Select the pre-alarm time for the alarm and motion recording.
Note:
The maximum pre-alarm time is 1800 seconds. The pre-alarm
time depends on the recording rate of the pre-alarm
recording. A maximum of 3600 images can be recorded for
each pre-alarm and by each camera. Example: 1 image/
second = 1800 seconds, 2 images/second = 1800 seconds,
4 images/second = 900 seconds, 5 images/second =
720 seconds etc.
Make the settings for alarm recording.
Select the recording rate.
Note:
The actual recording rate depends on the camera type and
the parameters set for the camera (e.g.: resolution,
compression setting).
Enter the post-alarm time.
Note:
The maximum post-alarm time is 999 seconds. The default
setting is 0 seconds.
Make the settings for continuous recording.
Select the recording rate.
Note:
The actual recording rate depends on the camera type and
the parameters set for the camera (e.g.: resolution,
compression setting).
Activate this check box to automatically delete data after a
specified number of days.
Enter the number of days after which data should be deleted.
Example: 3 means that all data older than 3 days is
automatically deleted.
deleted after a specified number of days.
Check box is not activated: protected data is not
automatically deleted.
Click the button to see the default settings.
Copies all tabs from the selected time period with all the
settings they contain into other time periods.
Click the button. A dialog box opens where you can select the
time periods.
The entries are saved.
DiBos/DiBos Micro
Bosch Sicherheitssysteme GmbH