Bosch DB18C3100R2 Installation Manual page 62

62 en | Default Configuration
7
8
9
10
11
12
13
F.01U.033.308 | V7 | 2009.09
Extended...
Extended settings
Pre-alarm time [sec.]:
Post-alarm time [secs.]:
Pre-alarm recording:
Quality levels
Assigned grabber power The system calculates, per camera tab (grabber) and time
Default settings
Copy settings to other
time periods...
Save
Installation Guide
Click the button. A dialog box opens. Here you can edit the
settings for each camera.
The information on pre- and post-alarm time and pre-alarm
recording are valid for the selected time period and for all
cameras on the camera tab.
Note:
If the cameras are assigned differing values, this is
indicated by an asterisk (*).
Select the pre-alarm time for the alarm and motion
recording.
Note:
The maximum pre-alarm time is 1800 seconds. The pre-
alarm time depends on the recording rate of the pre-alarm
recording. A maximum of 3600 images can be recorded for
each pre-alarm and by each camera. Example: 1 image/
second = 1800 seconds, 2 images/second = 1800 seconds,
4 images/second = 900 seconds, 5 images/second =
720 seconds etc.
Enter the post-alarm time.
Note:
The maximum post-alarm time is 999 seconds. The default
setting is 0 seconds.
Select the recording rate for the pre-alarm time. The
recording rate applies to alarm recording and motion
recording.
Click the button. A dialog box opens. You can add or edit
recording qualities (see also Section Specify recording
quality for analog cameras).
period, the sum of the recording rates for continuous and
motion recording. Alarms are not taken into account.
Note:
If the result exceeds the grabber power (more than 100%),
the user cannot save the settings.
Click the button to see the default settings.
Copies all tabs from the selected time period with all the
settings they contain into other time periods.
Click the button. A dialog box opens where you can select
the time periods.
The entries are saved.
DiBos/DiBos Micro
Bosch Sicherheitssysteme GmbH