Installing The System Board - Dell 8 Owner's Manual

11 Remove the video riser card or daughter card. See "Video Controller
(PowerEdge M905, M805, M605, and M600 Only)" on page 251.
12 Remove the memory modules and memory module blanks. See "Removing
Memory Modules" on page 195.
13 Remove the processor(s). See "Removing a Processor" on page 226.
14 Remove the storage controller board. See "Removing the Storage
Controller Board" on page 259.
15 Remove the NIC hardware activation key. See "System Board Connectors"
on page 316 for the location of the key.

Installing the System Board

1 Transfer the following components to the new system board:
• NIC hardware activation key. See "System Board Connectors" on
page 316 for the location of the key.
• Internal USB key.
• Storage controller board. See "Installing the Storage Controller Board"
on page 260.
• SD vFlash card (PowerEdge M910, M710, and M610 only). See "SD
vFlash Card (PowerEdge M910, M710, M710HD, M610, and M610x
Only)" on page 206.
• SD card. See "SD Card" on page 204.
• Memory modules and memory module blanks. See "Installing
Memory Modules" on page 194.
• Processor(s) and heat sink(s), or processor filler blank. See "Installing a
Processor" on page 239.
• HT bridge cards (PowerEdge M905 only). See "HT Bridge Card
(PowerEdge M905 Only)" on page 242.
• FlexMem bridges (PowerEdge M910 only). See "FlexMem Bridge
(PowerEdge M910 Only)" on page 241.
258
Installing Blade Components