Cf_P-Manetime Command; Cf_Standbymode Command; Cf_Sleeptime Command; Cf_Lamplifere Command - Sanyo PDG-DSU30 - 2500 Specifications

PDG-DSU30 Expand Serial Command Functional Specifications

8.10.8 CF_P-MANETIME Command

Command "CF_P-MANETIME_%1" [CR]
"000~180" ----------- Directly specify the timer to operate Power management
%1 "UP" ------------------- Increase the timer for Power management
"DN" ------------------- Decrease the timer for Power management
Set up Power Management. (Valid only in the normal Power ON status.)
The value set by this command is stored in EEPROM and its setting is
Details
effective even after ALL is OFF.
No display is shown when projector received command.
Acceptable
Correspondence
Unacceptable

8.10.9 CF_STANDBYMODE Command

Command "CF_STANDBYMODE_%1"[CR]
"ON" ---------------------- Select Standby
%1
"OFF" -------------------- Select Active
Set up Power mode . (Valid only in the normal Power ON status.)
The value set by this command is stored in EEPROM and its setting is effective
Details
even after ALL is OFF.
No display is shown when projector received command.
Acceptable
Response
Unacceptable

8.10.10 CF_SLEEPTIME Command

Command "CF_SLEEPTIME_%1" [CR]
"000~995 ----------- Directly specify the time to sleep
%1 "UP" ------------------- Increase the timer by 5steps
"DN" ------------------- Decrease the timer by 5steps
Set up Power Management. (Valid only in the normal Power ON status.)
The value set by this command is stored in EEPROM and its setting is
Details
effective even after ALL is OFF.
No display is shown when projector received command.
Acceptable
Correspondence
Unacceptable

8.10.11 CF_LAMPLIFERE Command

Command "CF_LAMPLIFERE_%1"[CR]
"ON" --------------------- Set Lamp Life Reminder On
%1
"OFF" ------------------- Set Lamp Life Reminder Off
Set up Eco. Standby (1w). (Valid only in the normal Power ON status.)
The value set by this command is stored in EEPROM and its setting is effective
Details
even after ALL is OFF.
No display is shown when projector received command.
Acceptable
Response
Unacceptable
"000" [CR]
"Error Code" [CR]
"000"[CR]
"Error Code"[CR]
"000" [CR]
"Error Code" [CR]
"000"[CR]
"Error Code"[CR]
26 / 42