Internal drives
Internal drives are devices that your server uses to read and store data. You can
add drives to your server to increase storage capacity and enable your server to
read other types of media. Internal drives are installed in bays. In this manual, the
bays are referred to as bay 1, bay 2, and so on.
Figure 5 shows the locations of the drive bays.
Figure 5. Drive bay locations
The following list describes the type and size of the drive that you can install in
each bay:
16
Installation and User Guide
1 Bay 1 - Maximum height: 43.0 mm (1.7 inches)
2 Bay 2 - Maximum height: 43.0 mm (1.7 inches)
3 Bay 3 - Maximum height: 25.8 mm (1.0 inch)
4 Bay 4 - Maximum height: 25.8 mm (1.0 inch)
Optical drive
Optical drive
3.5-inch secondary SATA hard disk
drive
3.5-inch primary SATA hard disk drive