Table of Contents
Advertisement
6. Press the cover-release button on the side of the server and slide the cover to
the rear of the server to remove the cover.
Figure 6. Removing the server cover
Removing and reinstalling the front bezel
Attention
Do not open your server or attempt any repair before reading and
understanding the "Safety" on page v and the Safety Information book. To
obtain a copy of the Safety Information book, go to:
http://www.lenovo.com/support
This section provides instructions on how to remove and reinstall the front bezel.
To remove and reinstall the front bezel, do the following:
1. Remove all media from the drives and turn off all attached devices and the
server. Then, disconnect all power cords from electrical outlets and disconnect
all cables that are connected to the server.
2. Remove the server cover. See "Removing the server cover" on page 18.
Chapter 5. Installing or replacing customer replaceable units
19
Advertisement
Table of Contents
