Panasonic UB-T880W Operating Instructions Manual page 4

Introduction
Help of the Software
Instructions for elite Panaboard software and elite Panaboard book (included) are provided in the help
information accompanying the software.
For details on accessing this information, see "Viewing the Help of the Software" (page 27).
Federal Communications Commission and Industry Canada Requirements
For United States and Canada Only
This device complies with Part 15 of FCC Rules and RSS-Gen of IC Rules.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired operation of
this device.
Federal Communications Commission Requirements
For United States Only
Note
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
FCC Warning
To assure continued FCC compliance, the user must use only shielded interface cable and the
provided power supply cord. Also, any unauthorized changes or modifications to this equipment
would void the user's authority to operate this device.
RF Exposure Warning:
This Electronic Board may be used with below referenced optional low power 2.4 GHz USB
Wireless Adaptor and Electronic Pen and may not be co-located or operated with any other
antenna or transmitter. These transmitters comply with FCC radiation exposure limits set forth for
uncontrolled environment/general population to meet the FCC radio frequency (RF) Exposure
Guidelines in FCC/OET Bulletin 65, Supplement.
This satisfies RF exposure evaluation by calculated Maximum Permission Exposure (MPE) without
the need for tested localized specific absorption rate (SAR) measurements.
Industry Canada Requirements
For Canada Only
This equipment complies with IC radiation exposure limits set forth for an uncontrolled equipment and
meets RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF
energy that are deemed to comply without testing of specific absorption ratio (SAR).
4 Operating Instructions