HP A3550A - High Availability Disk Arrays Model 20 Storage Enclosure User Manual page 300

Table 6-12 Extended Status Codes (Continued)
Extended Extended status code
status code name
0x28 Spindle synchronization
change
0x29 Not ready/start in progress
0x2A Transfer count not zero
0x2B Bad interrupt
0x2C Too much data
0x2D Bad bus phase
0x2E Bad message
0x2F Bad reselection
0x30 Parity error
0x31 Message parity error
0x32 Status parity error
0x33 Bad status
0x34 Invalid CDB
0x35 Unsupported function
0x36 No device driver
0x37 Unsupported IOCTL option
0x38 Unexpected disconnect
0x39 User reset
0x3A Protocol time-out
0x3B Recovered error cannot
remap
0x3C Recovered error remap
failed
0x3D Media error cannot remap
6-52 Unsolicited Event Log
Description
This error code should never be seen.
This error code should never be seen.
Too few bytes were transferred by a drive during an I/O
operation.
An unexpected or incorrect interrupt was received from a
SCSI protocol chip or drive.
Too many bytes were sent or requested by a drive during an
I/O operation.
A drive violated the SCSI bus protocol.
A drive violated the SCSI bus protocol.
A drive violated the SCSI bus protocol.
A SCSI bus parity error was detected.
A SCSI bus parity error was detected.
A SCSI bus parity error was detected.
A drive violated the SCSI bus protocol.
An invalid command was issued. This error code should never
be seen.
This error code should never be seen.
This error code should never be seen.
This error code should never be seen.
A drive violated the SCSI bus protocol.
The device was reset. This can be caused by a previous error.
A drive violated the SCSI bus protocol.
The device reported a Recovered error that required ECC to
recover the data (01/18), but it did not report the bad LBA in
the sense data. The SP microcode was unable to attempt a
remap.
An attempt to do a remap after a Recovered error failed for
some reason other than one of the following: another media
error, a timeout, cannot remap (no LBA provided), or bad
defect list. All of these errors are itemized separately.
The device reported a Media error (03/xx) but it did not report
the bad LBA, remap was not enabled.