Performing With A Song; Selecting A Song; Adjusting The Song Volume - Yamaha DTX400K Owner's Manual

Basic Techniques

Performing with a Song

The drum module comes complete with ten practice songs. Covering a wide range of genres, they
provide a convenient, enjoyable way to practice drumming.

Selecting a Song

1.
Press the [SONG] button.
2.
Press the [ ] button to start the current song.
3.
If you wish press one of the number buttons ([1] to [10/
0]) to select a different one.
1
•
You can stop song playback by pressing the [
ton once again.
•
If you wish to mute the programmed drum parts and hear
only the song parts, press the [DRUM MUTE] button. To
unmute the drum parts, press the [DRUM MUTE] button
once again.
•
The most appropriate drum kit is pre-assigned to each of
the drum module's songs, so whenever you select a new
song, the current kit will also change. If you wish to use a
different kit to play a certain song, please select that kit
after changing the song. For more details, see Quick select
from Song Mode or Training Mode (page 23).
NOTE
For detailed information on the ten built-in songs, see the Data
List section (page 60).
Quick select from Kit Mode or Training Mode
In order to select a song quickly without having to
leave Kit Mode or Training Mode, press and hold the
[SONG] button, and then press the number button ([1]
to [10/0]) for the desired song.
Hold
3
2
] but-

Adjusting the Song Volume

Using the following procedure, you can set the volume of
the current song to your preferred level.
1.
Press the [ ] button to start the song.
2.
While holding the [SONG] button, press either the
[VOLUME+] or [VOLUME–] button.
Hold
•
Each time you press the [VOLUME+] button, you
increase the song volume by one.
•
Each time you press the [VOLUME–] button, you
decrease the song volume by one.
DTX400K/DTX430K/DTX450K
Higher song volume
Lower song volume
25
Owner's Manual