Performing with a Song
Adjusting the Volume of Muted Drum
Parts
If you press the [DRUM MUTE] button while playing a
song, the drum parts from the song will be muted—that is,
their volume will be reduced to zero. If, however, you would
like the drum parts to be slightly audible in this type of situ-
ation, you can adjust the muted volume as described below.
1.
Press the [
] button to start the song.
2.
Press the [DRUM MUTE] button to mute the drum
parts.
3.
While holding the [DRUM MUTE] button, press either
the [VOLUME+] or [VOLUME–] button.
Hold
•
Each time you press the [VOLUME+] button, you
increase the volume of the muted drums by one.
•
Each time you press the [VOLUME–] button, you
decrease the volume of the muted drums by one.
By pressing the [DRUM MUTE] button once again, you
can unmute the drum parts and restore their normal vol-
umes.
26
DTX400K/DTX430K/DTX450K
1
2
Maximum muted volume
Minimum muted volume
Owner's Manual
Looping Part of a Song
As described below, you can have a song playback between
two points set in units of one measure. To do so, you simply
need to set a loop start point (A) and a loop end point (B)
while the song is playing.
A
Looping playback
1.
Press the [
] button to start the song.
2.
At point A, press and hold the [SONG] button and press
the [
] button.
Hold
3.
At point B, again press and hold the [SONG] button
and press the [
] button.
To stop looped playback, press and hold the [SONG] button
and press the [
] button.
NOTE
• When you select a different song, looped playback will be can-
celled automatically and points A and B will be reset.
• After an automatic lead-in (to help guide you into the phrase),
the range from Point A to Point B is played back repeatedly.
B