Replacing The Top Cover - HP D5970A - NetServer - LCII User Manual

Chapter 2
4. Release the top cover by turning the knob at the front of the chassis in a
clockwise direction. See Figure 2-2.
5. Slide the top cover about ½ inch (13mm) toward the front of the Netserver
and then lift it off the chassis.
Figure 2-2. Removing the Top Cover

Replacing the Top Cover

To replace the cover, follow these steps.
1. Ensure the knob on the cover is turned to the Open position (clockwise).
See Figure 2-3.
2. Place the rear edge of the top cover near the rear edge of the chassis, angling
the cover slightly to engage the hooks at the rear of the chassis. Then lay the
cover down on the chassis.
Opening and Closing the HP Netserver
11