Marking The Columns - HP D5970A - NetServer - LCII User Manual

Chapter 8

Marking the Columns

To make it easier to mount the HP Netserver in the rack, you may want to mark
the column holes that will be used by the Netserver. The Netserver may be
mounted using either flush-mount or center-mount brackets that attach to the front
side of the two columns. Use a marking pen or masking tape to mark the columns.
Use the HP Rack Configuration Tools to determine where in the rack to mount the
HP Netserver. The tools are available at:
http://www.hp.com/netserver/support
Use the marking pen or masking tape to mark the server position on the front of
both columns. See Figure 8-2.
The two brackets are mounted at the 1st and 5th holes on the columns, relative to
the bottom of the HP Netserver.
Fifth Hole
From Bottom
Second Hole
From bottom
Figure 8-2. Location Marks on the Rack's Front Columns
Rack Mounting the HP Netserver (2-Post)
Bottom of
HP Netserver
Left Right
Side
Side
Front of
Rack
Mark this face of
the columns with
masking tape
or marker pen.
79