Removing The Rear Chassis Blower/Bracket And Air Flow Guide - HP D5970A - NetServer - LCII User Manual

Chapter 2
Removing the Rear Chassis Blower/Bracket and
Air Flow Guide
The blower generates the air that cools the processor heatsinks. The air flow guide directs
air onto the processor heatsinks. The air flow guide sits directly over the DIMMs and
must be removed to install or remove DIMMS.
1. To remove the rear chassis blower/bracket assembly, tilt up the inside edge
of the rear chassis blower/bracket assembly.
2. Disconnect the blower power connector from the system board.
3. Lift out the blower/bracket assembly as shown in step 1 of Figure 2-4.
4. To remove the air flow guide, unplug the air flow guide fan cable from the
system board.
5. Lift up the air flow guide to remove it as shown in step 2 in Figure 2-4.
Figure 2-4. Removing the Rear Chassis Blower/Bracket and Air Flow Guide
Opening and Closing the HP Netserver
13