Exiting Scsiselect; Using Scsiselect Settings; Scsi Bus Interface Definitions - HP D5970A - NetServer - LCII Installation And Configuration Manual

During the startup process, pay careful attention to the messages that appear on
your screen.
2. When the following message appears on your screen, press the Ctrl-A keys
simultaneously (this message appears for only a few seconds):
Press <Ctrl><A> for SCSISelect (TM) Utility!
3. From the menu that appears, use the arrow keys to move the cursor to the
option you want to select, then press Enter.
NOTE If you have difficulty viewing the display, press F5 to toggle between
color and monochrome modes. (This feature may not work on some
monitors.)

Exiting SCSISelect

Follow these steps to exit SCSISelect:
1. Press Esc until a message prompts you to exit (if you changed any settings,
you are prompted to save the changes before you exit).
2. At the prompt, select Yes to exit, then press any key to reboot the computer.
Any changes made in SCSISelect will take effect the next time the computer
is booted.

Using SCSISelect Settings

To select an option, use the arrow keys to move the cursor to the option, then
press Enter.
In some cases, selecting an option displays another menu. You can return to the
previous menu at any time by pressing Esc.
To restore the original SCSISelect default values, press F6 from the main
SCSISelect screen.

SCSI Bus Interface Definitions

• Host Adapter SCSI ID—(Default: 7) Sets the SCSI ID for the SCSI
host bus adapter. The Ultra3 SCSI Host Bus Adapter is set at 7, which
17