HP D5970A - NetServer - LCII Installation And Configuration Manual page 41

[xxxxx096] Adapter hardware initialization failure—possible resource
conflict
The driver has attempted to initialize the adapter hardware but failed. This
might suggest that the adapter resources (e.g., IRQ) conflict with another board
installed in your system.
[xxxxx097] Unable to allocate memory
This indicates that there may be a problem with the amount of memory installed
in your system. Verify that your system has at least the minimum amount of
memory required by your operating system.
[xxxxx0af] Unable to de-allocate memory that was allocated for a target
device
Normally, this is not a serious problem, unless you get this message frequently
over a short period of time. The memory can be reclaimed by rebooting the
system.
[xxxxx0ce] Scatter/gather limit exceeded
An I/O request packet from the system contained a Scatter/Gather element list
that contained more elements than are supported by the miniport. Scatter/Gather
is a list of data segments that define the entire data transfer. Scatter/Gather is a
means to improve total data throughput. This error might be caused by a
component external to the miniport driver, such as the operating system or an
ASPI application.
[xxxxxd4] Adapter hardware failure - adapter reset
The host adapter hardware failed and the miniport has to reset the hardware.
[xxxxx0d6] Internal driver error
An error has occurred while the driver was setting up its internal data structures.
Try installing the most up-to-date version of the driver available from the HP
Web site located at http://netserver.hp.com/netserver/
35