Chapter 3
3. Remove the processor module from the mounting bracket assembly.
Removing a Processor Module With a Processor Retaining Latch
To remove a processor module that HAS a retaining latch:
1. Squeeze the two tabs on the outer edge of the processor retaining latch, as
shown in Figure 3-6. Disengage the two retaining hooks from the other
side of the processor ejector lever.
Disengage Two Hooks from
Processor Ejector Lever
Figure 3-6. Squeeze Tabs on Processor Retaining Latch, and Disengage
20
Processor Ejector Lever
Hooks from Processor Ejector Lever
Installation in LC 3 and LH 3/3r