Replace The Hp Netserver Lpr In The Rack; Reconnect The Netserver - HP D5970A - NetServer - LCII Installation Manual

Chapter 4
CAUTION Never operate the NetServer, even for a short time, without
first installing all covers and the front bezel. Operating the
system without all covers in place reduces critical cooling
airflow over some components, such as hard disk drives,
circuit boards, and processor modules. Operating the system
without all covers in place may result in failure of these
components.
NOTE
In an HP NetServer E 60, the front bezel must be in position
before you install the cover.

Replace the HP NetServer LPr in the Rack

For HP NetServer LPr, refer to your NetServer documentation and rack
documentation to replace the NetServer in the rack and replace the front bezel.

Reconnect the NetServer

If you upgraded to Pentium III processor modules, attach the Pentium III label to
a corner of the front bezel.
Connect the AC power cord and all cables. Refer to your NetServer
documentation for instruction.
Next, go to Chapter 5, "Verification," to ensure that the processor upgrade was
completed successfully.
Installation in E 60 and LPr
47