Remove The Hp Netserver Lpr From The Rack; Remove The Cover - HP D5970A - NetServer - LCII Installation Manual

Chapter 4

Remove the HP NetServer LPr from the Rack

For HP NetServer LPr, refer to your NetServer documentation and rack
documentation to remove the front bezel and remove the NetServer from the
rack.
WARNING
Do the following to prevent the rack enclosure from tipping
over:
Failure to take these precautions could result in serious injury
and equipment damage.

Remove the Cover

Refer to your NetServer documentation to remove the cover to gain access to the
system board.
NOTE In an HP NetServer E 60, unsnap the cooling duct and swing
it away from the processor modules.
38
Extend the anti-tip foot, or verify that the anti-tip feature
is installed.
Verify that the leveler feet are lowered.
Do not extend more than one piece of equipment at a time
out from the front of the rack.
Installation in E 60 and LPr