HP D5970A - NetServer - LCII Manual page 23

Chapter 2
Figure 2-3 shows an LPr rack installation with PDUs mounted in three ways:
Vertically on the rear rack column
Horizontally on the rear rack column
Horizontally on the extended version of the rear brackets that hold the
LPr chassis in the rack
Mounting of
four PDUs in a
rack of 20 LPr servers
Two Cable Guides
mounted on the
rear column on
same side as
door hinges
Once you have determined the general location and orientation, install the PDUs
for the rack as follows:
Connecting and Routing Cables to the HP NetServer LPr
Figure 2-3. PDU Mounting Options
208-240 VAC
wide-ranging
16-amp PDU
mounted horizontally
on rear columns
208-240 VAC
wide-ranging
16-amp PDUs
mounted vertically
on rear columns
208-240 VAC
wide-ranging
16-amp PDU mounted
horizontally on LPr
rear bracket
19