Configure The Settings Relating To The Camera Action On Alarm Occurrence [Alarm] - Panasonic WV-SC384 Operating Instructions Manual

Configure the settings relating to the camera action on alarm
occurrence [Alarm]
Click the [Alarm] tab on the "Alarm" page. (☞ Pages 26 and 27: How to display/operate the setup menu)
The settings relating to the camera action at an alarm occurrence can be configured in this section. Refer to pages
75, 77 and 79 for further information about the settings relating to the alarm, the alarm image and the alarm output
terminal.
■ Camera action on alarm
[Terminal alarm 1]
Select an action to be taken when a terminal alarm 1 is
detected from the following.
Off: Does not take any action even when a terminal
alarm 1 is detected.
1-64: When the registered preset position is selected,
the camera will move to the selected preset position
when a terminal alarm 1 is detected.
Auto track
SW395 SC385
is detected, the camera will start the auto tracking.
Default: Off
[Terminal alarm 2]
Select an action to be taken when a terminal alarm 2 is
detected from the following.
Off: Does not take any action even when a terminal
alarm 2 is detected.
1-64: When the registered preset position is selected,
the camera will move to the selected preset position
when a terminal alarm 2 is detected.
Auto track
SW395 SC385
is detected, the camera will start the auto tracking.
Default: Off
: When a terminal alarm 1
: When a terminal alarm 2
[Terminal alarm 3]
Select an action to be taken when a terminal alarm 3 is
detected from the following.
Off: Does not take any action even when a terminal
alarm 3 is detected.
1-64: When the registered preset position is selected,
the camera will move to the selected preset position
when a terminal alarm 3 is detected.
Auto track
SW395
is detected, the camera will start the auto tracking.
Default: Off
[VMD alarm]
Select an action to be taken when a VMD alarm is
detected from the following.
Off: Does not take any action even when a VMD alarm
is detected.
1-64: When the registered preset position is selected,
the camera will move to the selected preset position
when a VMD alarm is detected.
Auto track
SW395
detected, the camera will start the auto tracking.
Default: Off
[Command alarm]
Select an action to be taken when a command alarm is
detected from the following.
Off: Does not take any action even when a command
alarm is detected.
1-64: When the registered preset position is selected,
the camera will move to the selected preset position
when a command alarm is detected.
Auto track
SW395
is detected, the camera will start the auto tracking.
Default: Off
76 76
: When a terminal alarm 3
SC385
: When a VMD alarm is
SC385
: When a command alarm
SC385