A Customizing The Hp Autopilot Hp Netserver; Installing Nsa Software Agents Manually On Netware Servers; Loading The Asr Software For Novell Netware - HP D6030A - NetServer - E50 Installation Manual

A Customizing the HP AutoPilot HP
NetServer
This appendix covers the procedures for a customized installation of HP AutoPilot
Server software (NSA 3.0). Do not attempt to customize HP AutoPilot's NSA software
unless you are a confident network administrator and understand the use of command
line parameters.
Installing NSA Software Agents Manually on
NetWare Servers
As you add or reconfigure Novell NetWare servers, you may opt to install NSA server
agents on each server independently. If you want to install or reinstall the software at
a later date, you can use the HP AutoPilot Client installation program found on the HP
AutoPilot Client Diskette to install the software without reinstalling the rest of the HP
AutoPilot program files.
If your AUTOEXEC.NCF file does not include the HP nsaload command, the HP
AutoPilot software (which is made up of several NLMs) will not load automatically
whenever the server is started. If so, you will then need to load the software manually
each time you start the server.
To load the HP AutoPilot manually on your Novell NetWare servers, type the
following at your server's HP AutoPilot Client:
nsaload

Loading the ASR Software for Novell NetWare

If you installed the HP AutoPilot software on your server through the HP AutoPilot
installation program, the ASR NLMs were copied to that server and enabled
automatically. If you have done this, skip to step 4. Otherwise, proceed to step 1.
Note that this installation procedure assumes that a Novell NetWare server and client
have already been set up and are working correctly.
25